Project Flat Panel Samsung LCD install

[Kris Guilbeaux]

This Thread is to show the install of my New 23" Samsung Flat panel install.

Thread will include pictures so stay Tuned.

Install will be Mounting the TV to the Wall, running the Electrical and setting up surge protection built in to the Wall for clean installation.

This is a No Wires hanging install. the Way it was meant to look...

Stay tuned

[Kris Guilbeaux]

So hunting all the parts to do a clean install with no cords Showing turned out to be a quite a chore.. So needless to say I made some pieces to do this.

First order was to Run a in wall RCA line with along with Cable TV wire.

I found this Product at Radio Shack which would work perfect behind the dresser but lacked TV cable. I bought two one to use as is and one to use for parts.



I purchase the The next parts at Lowes to make my own plate to make use off the RCAs and Cable TV.







I drill holes in the blank plates, attach the RCAs and Cable to the blank.







Walla!!!



Next To cut the proper holes in the Sheet rock.



I tied My Elec into the plug exactly below where the New Tv would go. I turn off the breaker to the room and remove all the Existing Metal box for the plug. and install New Deep Remodel Boxes and Low Voltage boxes for the RCAs and Cable.







I purchase a outlet Surge protector for the TV this was purchased at an Electrical store in Victoria. Cable was ran in the Attic and Drilled a Hole threw the Header to run the cable in the wall. I lost a Few pounds in the Attic this Morning. LOL



At that point I secured the Wall mount for the TV to the Stud in the Wall and hooked Every thing up..

[FROADER]

Nice clean install Kris.

[wilander]

That is a wonderful install. What type of Surge protector did you use and where did you mount it?

[Kris Guilbeaux]

[Justin Klare]

[SVO]

[Tripany]

[XanaDorn]