Demon4x4.com

Fogs are in.

Nice, were the factory mounts already there or did you have to rig it up to fit them in? Wired in to work?

No, they weren't available as an option for my year, apparently. I had to get the mounts, remove the bumper and then drill holes in the bumper for the mounts, as well as clearance some of the plastic trim to get them to fit. It's mostly wired up, I'm still waiting on a rocker switch to come in the mail.

Going to put led bulbs in them?


Sent from you guessed it.

I put Silver Star 9005's in them.

Do they have levels on the back to aim them or you going to have to do it once they're wired in so you can turn them on and do if against a wall?


Sent from you guessed it.

Yes to both.

Did you ever get the left rear door fixed ?

Just got in the new cable a couple days ago. Just need to install it. (Which involves drilling out some rivets).

Get the cable off e-bay?

Yes, I did.

Nice.


Sent from you guessed it.

Ok, help me out with this wiring. Lol



Should I assume that 85 = blue wire, and 86 = black wire? If that is correct, Does blue go to pin three on the switch? Pin seven on switch I'm thinking should be tapped into parking lamps, but what of pin 2?

Ok, here's what you need to do. First, if you look on the bottom side of the relay, the numbers will be printed on the bottom side (30, 85, 86, 87, and 87A) so you know where each wire plugs into it. Refer to figure 1


(Figure 1)

next, do the following (In no particular order):

1) Connect your ground wire to pin 86 on the relay
2) Connect the fog lamp positive wires to pin 87
3) Connect 12V hot at all times (Battery voltage) to pin 30
4) Connect PIn 85 to Pin 3 on the switch
5) Connect Pin 7 on the switch to ground
6) Connect Pin 2 to the brown wire on the turn signal pigtail (make sure this is fused)

That should be all you need to do to make it work and the switch to light up when the fogs are on. As far as your question on which pins the blue and black wire go, i cant answer that since I cant see where you plugged them into on the relay.

Ok, I'll have to look at what pins the blue and black wire are connected to on the relay, as the relay came pre wired. Thank you sir!

No problem, sorry for the delay!

Thanks parker

wth happened?

Maybe you shouldn't leave burritos laying in the drivers seat that someone wants....


Sent from my iPhone 5

Someone tried to break into my truck last night, using a common easy access point on these model years of super duty. Lucky, I knew about this, and installed a Jimmi Jammer, which is basically a steel plate that blocks a screwdriver's entry at that point.

You should buy a gun

Sent from my SGH-M919 using Tapatalk 2

Gun doesn't do much good while you sleep and they break into your vehicle in the middle if the night....just saying.


Sent from my iPhone 5