Demon4x4.com

Ok guys here is the Total Cost for the Bolt on kit with a completely rebuilt Dana 44 with 4.88 open, Moser Axles, new hubs and new brakes every thing with 8" lift front and rear. <br><br>$4823.00 plus freight.<br><br>There is one down side to this This will be a low pinion Dana 44. JBG does not want to cut down the High pinion.<br><br>What do you guys think?<br> <br><br> <p></p><i></i>

well, you could order that high pinion axle that hase been cut down to EB specs from <!--EZCODE LINK START--><a href="http://completeoffroad.com">completeoffroad.com</a><!--EZCODE LINK END-->, and just order the reat of the part through JBG, including reverse gears instead of standard, and see if they will give you a quote for that. The cut down hp axle runs $399. You'd have to install averything, but it might be cheaper in the long run. <p><a href="http://Demon4x4.com/Mudd">91 Moab Edition</a><br><a href="http://Demon4x4.com">Demon4x4.com</a><br><a href="http://Explorer4x4.com">Explorer4x4.com</a></p><i></i>

That is what I was thinking of doing. Buy a cut down High pinion Axle and Order the stage II fabritech kit for $2200.00 I can Build a dana 44 up my self and I can install the gears myself. <br><br>Kris <p></p><i></i>